Lead acid batteries Wet batteries (most commonly used battery type). The PRO25S offers a special charging mode for each type of battery, so that each battery is charged according to its individual requirements. Only the charging mode for lithium batteries has to be selected manually, all other battery types are recognized by the charger and the appropriate charging characteristics are selected automatically. With the "Supply" mode, the charger delivers continuous current even without a battery being connected.
So it also serves as a power source Diagnosis and troubleshooting and continues to supply the vehicle with power when the battery is disconnected. This means that all the important configuration data are retained in the on-board computer and radio. The integrated temperature sensor on the charger adjusts the charging rate depending on the ambient temperature in order to achieve maximum charging performance. Higher temperatures lower the charging voltage, lower temperatures increase it.The temperature sensor is attached to a cable next to the terminal cable and can thus measure the temperature environment directly on the battery. The "Recond" mode enables the formation of acid layers to be reversed in older and deeply discharged batteries, thereby reducing the The power of the battery is restored and its life is extended. This reconditioning program is recommended for older, weak or deeply discharged batteries. It can be used with all types: wet cells, Ca / Ca (calcium), AGM, batteries, but should not be used with gel batteries. The Recond mode is not relevant for lithium-ion (LiFePO4) batteries and therefore cannot be selected. Nowadays all modern vehicles come with a CAN bus system fitted. Just opening a door or switching on the radio causes the system to become active. Even in mid-range vehicles, currents of approx.
20 amps and more flow. This can lead to the battery charge status being so bad after maintenance work that the vehicle can no longer be started. The high-frequency charger PRO25S is ideally suited for buffer operation. It comes with a 2 year guarantee.
All CTEK devices are easy to use, easy to connect, protected against sparks and protected against polarity reversal. The integrated security functions protect the vehicle electronics and battery. Due to the low ripple of voltage and current, they are safe to use Ideally suited for sensitive vehicle electronics. The battery of your vehicle does not have to be disconnected from the vehicle for charging.
Once set, the CTEK charger remembers the last settings used. Deeply discharged batteries can also be repaired. The charger can always remain connected, just plug it in and forget it, even for years.Here is a video about the CTEK PRO25. CTEK PRO25 - How do you use yours? Here is a video about the 8-step charging process and the way the CTEK devices work. CTEK 8 STEP LOADING PROCESS - YouTube. CTEK PRO25S charger (with normal power connection - Schuko).
CTEK charging cable for direct connection to the battery using "clamps" and temperature sensor cables. Battery types: All types of lead-acid batteries, lithium-ion (LiFePO4), wet, maintenance-free, Ca / Ca, AGM, Start Stop (EFB), gel batteries. Battery capacity lead-acid batteries: 40500 Ah. Lead acid battery output: 14.4V / 15.8V / 13.6V, 25A max. Output LiFePO4 batteries: 13.8V / 14.4V / 13.3V, 25A max.Length of charging cable: 2.00 meters. Length of power cord: 1.90 meters. Input: 220240VAC, 5060Hz, 2.9A max.
Starting voltage: 2.0 volts. Back discharge current: Less than 1 Ah / month. Ambient temperature: -20 ° C to +50 ° C.Temperature compensation: connected external charging voltage temperature compensation sensor. Dimensions: 235mm x 130mm x 65mm.
Please scroll for more information. CTEK Sweden AB Rostugnsvägen 3 SE-77670 Vikmanshyttan Sweden. The guarantee is valid throughout Europe.The guarantee applies to manufacturing and material defects. The guarantee is only valid within the guarantee period. A product is only defective if the product does not meet the relevant product specifications given in the user manual for the product, or if the defect is due to a material or manufacturing defect. The guarantee is invalid or does not apply for. Products that are opened incl.
Broken seal, intentionally damaged or otherwise modified or altered. Products not from CTEK or its authorized agents have been repaired. Products used in conjunction with supplies or accessories not approved in writing by CTEK or supplied by CTEK. Improper application or non-compliance with the instructions for installation, commissioning, operation or maintenance (ie not in accordance with the operating and installation instructions). Unauthorized modifications, changes or repair attempts.Vandalism, destruction by external influences and / or people / animals. Failure to comply with applicable safety standards and regulations. Failures caused by fire, water, snow, moisture, or other liquids not specified for normal use. Products whose serial number has been defaced, modified or removed. Any application of the product that does not conform to the design of the product or does not correspond to the intended use specified by CTEK.
Any installation and / or modifications that prevent the intended use of the product. Normal wear and tear and minor damage such as B. (but not limited to) corrosion, scratches, dents, rust, stains and non-functional parts such as B.
(but not limited to) plastics and coatings. Damage, errors, failures or defects caused by misuse, manipulation, illegal use, negligence or too long use. Or errors caused by the customer / user in some other way.Complaints sent directly to CTEK by the end user will not be accepted. In this case, the customer must bear the transport costs. If the guarantee period has expired, the product will be scrapped without further investigation. MotoUnion Manuel Hetzel Eyachstrasse 32 72459 Albstadt. Defective products will be repaired or replaced by an equivalent product at CTEK's expense. Defective and irreparable products are scrapped by CTEK. Furthermore, CTEK SWEDEN AB is not obliged to give any guarantees other than these. CTEK reserves the right to vary the terms and conditions mentioned here due to change (s) in the availability of services, products and / or spare parts or for the purpose of complying with applicable guidelines, rules, regulations and laws without prior notice, to modify or change. Ripple: less than 4% Weight: 1.8 kg Charger battery type Lead-acid batteries Charger battery type Gel batteries Charger battery type AGM batteries Charger battery type Charger battery type Charger battery type CTEK guarantee 2 year guarantee 190 cm 200 cm 25.0 amps (A) IP44 Charger volt 12 volts CTEK Sweden AB Rostugnsvägen 3 Sweden MotoUnion Manuel Hetzel Eyachstrasse 32 72459 Albstadt.
Autoladegerät Bagger Batterie Batterieladegerät Batterien. Baumaschinen Boot Bus compensation CTEK Dauerladegerät. EFB Start Stop Batterien und Lithium Ionen LifeP04 geeignet. Lastkraftwagen LKW mit MODELL MXS MXS25 NEU.PKW PKWLadegerät Quad Radlader Rasentraktor. PRO25S der MXS25 Nachfolger, neue Version. Reconditionierung Schiff Säure temperature Blei. Supply Modus Netztgerät Dauerstrom Recond Erhaltungsladung. Temperaturkompensation Traktor Transporter V Volt Wagen.
The item "CTEK MXS25 Successor PRO25S Charger Also For Lithium Start Stop Efb Batteries" is in sale since Saturday, April 3, 2021. This item is in the category "Vehicle Parts & Accessories\Garage Equipment & Tools\Battery Testers & Chargers\Chargers & Jump Starters". The seller is "motounion" and is located in Albstadt. This item can be shipped worldwide.